UHF CB Australia is funded by the generous donations from our supporters, Show your support and donate safely using PayPal and help keep these vital services going
   Home      UHF CB Tutorials      Coax Connectors Made Easy
The How To Guide

Need assistance with your next project why not email us at info@uhfcb.com.au and we will add a guide for you

Coax connectors made easy

Step 1
Strip the outer layer of the coax cable to reveal the braid (Earth)
Step 2
Trim back and fold the braid back over the coax cable.
Step 3
Strip off the inner conductor so it can fit into the center pin of the connector.
Step 4
Insert the coax into the connector and trim off the excess and solder the tip. Do not heat up too much or you may damage the connector. Only use enough solder to fill the tip of the center pin.
Step 5
Using a multimeter test for an open circuit by holding the probes against the center pin and the outer casing.


Show your support
Like us on Facebook
& Google +1
Subscribe to our YouTube Channel
and following us on Twitter

!-- Start of StatCounter Code -->